Components List for Refrigerator Panel Roll Forming Machine
|Roll Former (Cantilever forming model)||1set|
|Plate End Bending Device||1set|
|Un-powered Support Table||1set|
|Hydraulic Drive Control System||1set|
|Electric Control System||1set|
Technical Specification for Refrigerator Panel Roll Forming Machine
|Raw Material||Cold-Rolled Steel, Galvanized Steel|
|Thickness||0.8 - 1.0mm|
|Coil Width||according to final design|
|Coil Inner Diameter||Φ508±20mm|
|Coil Outer Diameter||≤Φ1200mm|
|Coil Weight||≤ 3Tons|
|Roll Forming Speed||10M/min (not including the Cutting time)|
|Power Source||380V±10%, 50-60Hz (according to buyer’s request)|
Working Flow for Refrigerator Panel Roll Forming Machine
De-coiling → Leveling → Guiding → Servo Feeding → Punching → Cutting → Rollgang → Guiding
→ Roll Forming → Plate End Bending → Plate to Support Table
Profile drawing for Refrigerator Panel Roll Forming Machine
Layout drawing for Refrigerator Panel Roll Forming Machine
Roller Shutter Door Forming Line
the main device of door shutter roll forming machine adopts combine roller station style. It is chain transmission, AC motor drives, through frequency to adjust speed. Rollers material is Cr12 steel with heat and surface polish treatment....
Dry Wall Roll Forming Machine
The dry wall Roll Forming Machine adopts the Individual Roller Station, drives by Gear Box. Adjust and install the Spacers to produce different width Dry Wall Plates....
Refrigerator Panel Roll Forming Machine
Cantilevers drive by gear, this type roll former advantage: adjust the plate width quickly. After cutting sheet, the sheet goes for roll forming, sheet goes though the Roller Stations one by one, and finally the sheet becomes the plate....
Electrical cabinet post roll forming machine
The main roll former about the electrical cabinet post roll forming machine uses single forming stand model, welded steel base plate....
Filter frame roll forming machine
The cutter model about the filter frame roll forming machine is flying cut; it is continuous cut style;There is no waste piece after cut actions....
Pipe support profile roll forming machine
The Main roll former about the pipe support profile roll forming machine can produce 41×41mm and 41×21mm pipe support profile at same machine....
Double row Special roof forming machine
Double row special roof forming machine is including two hydraulic stations.The hydraulic system is developed aiming to the multi-station punching machine....